WiSM version 6 Cannot modifiy service interface

Unanswered Question
Jun 20th, 2009

Can any body help me with this

although cisco sw advisor said that the best IOS for my hardware 6509 Sup720 IOS: (s72033_rp-IPSERVICESK9_WAN-M), Version 12.2(18)SXF16 suits the WiSM; And I tested it already with WiSM version 5.0 but when I've upgraded the WiSM to version 6.0 the service interface from the switch side says:

B5_Noc2_CS1(config)#int gig 4/9

% This interface cannot be modified

can anyone solve this issue; as the customer refuse to upgrade the switch IOS & He wants to use the latest ED WiSM sw 6.0; so please Help !!!!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
weterry Sat, 06/20/2009 - 19:39

I think 12.2(18)SXF5 introduced the wism commands, so you should not be modifying any of the gig interfaces directly..

The service port is normally modified by the wism commands (something like: wism service vlan XXX)

I am pretty sure you should not be modifying these gig interfaces directly.

Using the wism commands will set up the port channel with the correct vlans.

savadkmuhammed Mon, 10/08/2012 - 05:28

Hi,

Please allow all vlans in trunk configurations and that should bring the port chanel up.

No need to configure or modify the interfaces since the configurations are automatically done..

Hope this helps...

regards,

Savad

Stephen Rodriguez Mon, 10/08/2012 - 05:32

You don't want to allow all calms up to the wism. Only allow the ones that you have dynamic interfaces created for.

Steve

Sent from Cisco Technical Support iPhone App

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode