show interface transceive detail on C3650g

j.han · ‎06-21-2009

Hi Netpro:

here is my question:

why router prompt me:Diagnostic Monitoring is not implemented.when I use command"sh int trans detail to output optical receive power"

do I need additional configuration if use this command?

version 12.2(50)

Switch#sh int g0/25 transceiver properties

Diagnostic Monitoring is not implemented.

Name : Gi0/25

Administrative Speed: auto

Administrative Duplex: auto

Administrative Auto-MDIX: on

Administrative Power Inline: N/A

Operational Speed: auto

Operational Duplex: auto

Operational Auto-MDIX: on

Media Type: 1000BaseZX SFP

Switch#sh int g0/25 transceiver detail

Diagnostic Monitoring is not implemented

thanks all

Giuseppe Larosa · ‎06-21-2009

Hello Jianghui,

Sam has explained the DOM feature in the other thread you opened:

From Sam's post:

Not all modules are DOM capable, see compatibility here:

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_8031.html

So you need to verify if your optical modules support monitoring but you may need also some command in global config mode as explained by Sam.

Hope to help

Giuseppe

j.han · ‎06-22-2009

Hi Giuseppe:

I checked config and command doc for 12.2.50 version,but I can't find out which command I can config this funcion on cisco3560g,what you mendtioned some command in global config mode is the key.

BTW the SFP is supported by DOM

thanks

Giuseppe Larosa · ‎06-22-2009

Hello Jianghui,

Sam mentioned the following command

transceiver type all

but now I'm not sure it is given in global config and also I'm afraid this platform doesn't support DOM.

I've tried on a C3560E we have and I cannot find any option to give this command it is not present in global config and in interface mode

Hope to help

Giuseppe

cisco_lad2004 · ‎06-22-2009

Credit to the gentleman who gives credit :-)