06-22-2009 05:29 PM
I'm installing a ACE appliance using two L3 vlans, one for the client-side connections and the other for the server-side connnections. The VIPS are not part of the IP space assigned to either vlan. I am not able to ping or connect to the VIPS or see them in the ARP table. Is this a valid configuration?
Thanks!
06-23-2009 02:45 AM
This is a valid config.
But since the vip does not belong to any vlans, you need a static route upstream pointing the traffic to an interface ip of ACE.
Gilles.
06-23-2009 07:15 AM
I figured out what the issue was and it had nothing to do with the routing or interface setup. If you add an rserver to a server farm without a port, add the same rserver with a port and then remove the rserver without a port designation the ACE will not forward traffic to that server. You have to remove the entire serverfarm from the configuration and re-add it before it will function correctly.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: