logging problem

Unanswered Question
Jun 23rd, 2009
User Badges:


My Cat4506 didn't show terminal logs when i changed configuration ex. i shutdown interface but it showed only

"%SYS-5-CONFIG_I: Configured from console by". I configured logging buffer debugging and logging monitor debugging , it should show the log interface up/down or admin down. why ?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Istvan_Rabai Tue, 06/23/2009 - 01:31
User Badges:
  • Gold, 750 points or more


Use the "show logging" command to check your logging levels to different facilities.

Use the "logging console informational" to set the logging level for your console. It will then copy the interface up/down messages to the console port.



Rojer-bkk Tue, 06/23/2009 - 01:43
User Badges:


I tried to connect via vty ,key command terminal monitor and show logging but it didn't show anything except "%SYS-5-CONFIG_I: Configured from console admin via vty0"

I wondering about this. pls suggest me


davy.timmermans Tue, 06/23/2009 - 02:55
User Badges:
  • Silver, 250 points or more

if you do show logging, is logging monitor disabled?

else: config)# logging monitor

On certain images for 4500 and 6500, link status logging is globally disabled

glen.grant Tue, 06/23/2009 - 03:36
User Badges:
  • Purple, 4500 points or more

You must the command "logging event link-status" at the global or interface level to see interface up/down conditions .


This Discussion