ASA 5505 icmp-reply rate limit and burst limit

Unanswered Question
Jun 23rd, 2009

Hi all,

I've notice that I can set icmp unreacable limit and burst-limit with the command `icmp`. Is it possible set also icmp-reply and other type of icmp ? Best regards to all

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ebreniz Mon, 06/29/2009 - 10:46

The other icmp commands are as follows:

1) icmp {permit | deny} ip_address net_mask [icmp_type] if_name

2)icmp-object icmp_type

alessandro.fachin Mon, 06/29/2009 - 23:25

Thanks for reply. I known these instruction but with them I can't set limit or bust limit! I can only set if they are permit or deny... Any solution ?


This Discussion