×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Setting up AP in Sniffer mode

Unanswered Question
Jun 23rd, 2009
User Badges:

Looking for information that the sniffer trace just doesn't show me.

I have the AP setup in sniffer mode. I went to the controller that the AP is homed to. I'm capturing the data to wireshark.

I'm debugging the packets as AiroPeek. I can't seem to capture the clients initial connections i.e. dhcp request and handshakes.

Have I missed something ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 06/24/2009 - 15:07
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

I'm not sure what firmware version you've got, but try this:


Configuring Wireless Sniffing

http://www.cisco.com/en/US/docs/wireless/controller/5.1/configuration/guide/c51err.html#wp1042843


Hope this helps.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode