Error Fax

Unanswered Question
Jun 23rd, 2009


i have some problemx with a fax, incoming fax in error, i get just some part of the fax and i had an error.

I have configured them with CCA 2.0 analog port fxs 0/0 is in mode "FAX" signal "loop start" extension "301"

Some fax are good and other are incomplete, what can i do?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marcos Hernandez Tue, 06/23/2009 - 08:45

Please try the following configuration


voice service pots

  fax rate voice


Let me know if that helps,


Marcos Hernandez Tue, 06/23/2009 - 08:48

Tenet to the UC500 (, login and then enter configuration mode by typing "conf t". Enter the commands I gave you earlier and then type "exit". Finally save your config with "write mem".



This Discussion