06-23-2009 07:32 AM - edited 03-21-2019 01:14 AM
Hi,
i have some problemx with a fax, incoming fax in error, i get just some part of the fax and i had an error.
I have configured them with CCA 2.0 analog port fxs 0/0 is in mode "FAX" signal "loop start" extension "301"
Some fax are good and other are incomplete, what can i do?
Regards
06-23-2009 08:16 AM
What is the PSTN connection? Is it a SIP trunk?
Thanks,
Marcos
06-23-2009 08:23 AM
the pstn connection is BRI french numeris
06-23-2009 08:29 AM
Please attach a "show run". Don't forget to hide the passwords/
Marcos
06-23-2009 08:33 AM
06-23-2009 08:45 AM
Please try the following configuration
!
voice service pots
fax rate voice
!
Let me know if that helps,
Marcos
06-23-2009 08:46 AM
where i copied this line?
06-23-2009 08:48 AM
Tenet to the UC500 (192.168.10.1), login and then enter configuration mode by typing "conf t". Enter the commands I gave you earlier and then type "exit". Finally save your config with "write mem".
Marcos
06-23-2009 09:15 AM
invalid input detect when i type voice service ports
06-23-2009 09:33 AM
It is "voice service pots", not "ports"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: