unable to get to internet

Unanswered Question
Jun 23rd, 2009

Hi all. I had to create a vpn profile today on the ASA that does NOT allow split tunnel. Everything seemed to go well, but I cant get to the internet once I connect. Login is OK etc, I get the right address but it ends there. I know I forgot a stupid line somewhere I just cant figure it out.

This is the tunnel group in question (config attached (I hope))

tunnel-group rtptacvpn type remote-access

tunnel-group rtptacvpn general-attributes

address-pool newpool

authentication-server-group ehr

default-group-policy newpolicy

tunnel-group rtptacvpn ipsec-attributes

pre-shared-key *

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
George Thomas Tue, 06/23/2009 - 13:37

Did you specify a DNS server? Also, are you able to ping an external IP address?

mx Tue, 06/23/2009 - 14:03

Thank you for the reply, let me verify if I can ping by address...

mx Thu, 06/25/2009 - 07:47

as an update, I cannot ping anything by address. I did add dns-server value to the group policy but still no joy.

Also, I cant ping anything on the inside either. :(


This Discussion