E1 configuration for PBX synchronization . . .

Unanswered Question
Jun 23rd, 2009

Hii,

How to configure E1 . Please do guide me , and also suggest how can we do this for PBX signalling .

I have a Stream from ISP directly terminating from MUX to fast ethernet port0/0 . And i have installed VWIC 1MFT E1/T1 card .

Please suggest on this as it showing me E1 has come up but my PBX showing only layer 1 active , call is getting disconnected after 6-8 seconds. And I don't have any incoming call either .

Thanks in Advance,

Max

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
csco_sai9k Tue, 06/23/2009 - 18:58

Do I need to make add any additional commands , what should be the general E1 configuration ?

Actions

This Discussion