Nesting Macros

Unanswered Question
Jun 24th, 2009

Is there a way to call interface level macros from global macros on the 3560 series switches (12.2.44.SE1)?

I have a defined interface level macro that I would like to be able to call from a global macro and apply to a range of interfaces.

Yes, I know that I could easily just apply it from the int range command without a global macro, but this way, I could pre-define the range without worrying that I am affecting a port that requires a different config.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion