Wireless Controller 4404 - 4 Uplinks

jcerero77 · ‎06-24-2009

Hello! I have a wireless controller 4404, running 4.2.176.0 code. I have LAG enabled but currently have only 2 ports used, I am planning on connnecting the other two ports soon. Will this cause an outage? I am thinking no, but I want to see if anyone has ever done this and what the outcome was. Thank you.

Leo Laohoo · ‎06-24-2009

Are you plugging the last 2 uplinks to the same switch?

Just make sure that STP is DISABLED and it should be fine.

jcerero77 · ‎06-25-2009

Yes I am plugging the last two uplinks to the same switch, but on a different module. When you say make sure that STP is disabled, what are you referring to? Spanning-tree portfast?

Leo Laohoo · ‎06-25-2009

Yes. Just make sure STP Portfast is disabled.

dancampb · ‎06-26-2009

Also make sure you create an ap-manager interface for every active port on the controller.

mat.edwards · ‎06-27-2009

LAG is enabled so there will only be one AP Manager interface. No requirement/ability to create additional interfaces.