UC520 as h323 Gateway and CME simultaneously

dsuntama · ‎06-24-2009

Hi,

I would like to know whether I can configure UC520 as h323 gateway for CallManager and at the same time I install CME on it ?

If possible, how is the connection betwen CUCM and CME ?

Thanks

paolo bevilacqua · ‎06-24-2009

Yes, it is no problem.

However since the datasheet says CUCM is not supported, the TAC will not support you on that aspect.

kelvin.blair · ‎06-25-2009

That is correct. TAC will not support this type of configuration. All you need to do to accomplish is set the UC520 up as an H323 gateway in CUCM and configure your voip dialpeers on your UC520 to point to the CUCM.

dsuntama · ‎06-29-2009

Hi,

Thanks for the answer.

For example I have this scenario :

UC520 with CUE (CME license)

let say I will forward a DN on CUCM to a virtual DN on CME then all the calls to the Virtuan DN on CME will be forwarded to VM (CUE)

is it possible ?

How is the configuration ?

Thanks

paolo bevilacqua · ‎06-30-2009

ephone-dn xx

call-forward all

However if you're just trying to integrate CUE to CUCME, just do that directly.

dsuntama · ‎06-30-2009

How is the connection between CCM and CUCME if i want to use the UC520 as h323 gateway and CUCME simultaneously ?

I cannot add another trunk with UC520 IP Address since it's already configured as h323 gateway

Appreaciate your help

Thanks

paolo bevilacqua · ‎07-01-2009

As H.323 GW is enough, then you configure some route pattern to use it.