Tunnels down since upgrade

scottwclarke · ‎06-25-2009

Hi Everyone,

I upgraded the firmware on one of our firewalls to 8.2 today and since the upgrade no tunnels are forming I just get queing key aquire messages repeatedly.

I have confirmed the config is the same as it was and everything else is working fine.

I have googled but don't see anyone else having this problem.

Very greatful for any help

scottwclarke · ‎06-25-2009

Update one tunnel seems to come up but will only transmit data not recieve.

I have tried a crypto isakmp nat-traversal 10 but no joy

auraza · ‎06-25-2009

Can you post the output of the following:

1) show crypto isakmp sa

2) show crypto ipsec sa

3) show run

Also, what have you tried so far to make this work?