06-25-2009 04:31 AM - edited 03-15-2019 06:41 PM
It's a long shot but has anyone any experience on connecting an ISDN10 from SingTel in Singapore to a CME on a 2811 router? I guessing a VWIC2-1MFT-T1/E1 would be the right interface card?
What framing and line code are required also is this a PRI or R2 type trunk?
A sample working config would be greatly appreciated.
Thanks
Solved! Go to Solution.
06-25-2009 04:38 AM
That is the right card. As the name says, it's ISDN PRI. You configure pri-group with ten channels and that's it. You also need a minimum of pvdm2-16.
06-25-2009 04:38 AM
That is the right card. As the name says, it's ISDN PRI. You configure pri-group with ten channels and that's it. You also need a minimum of pvdm2-16.
06-26-2009 12:48 AM
Thanks.
07-16-2013 07:34 AM
Hi
Were you able to get this to work?
I am looking at some Cisco docs that say it's supported in 2900 only
Thanks
07-16-2013 07:46 AM
You are responding to a 4 years thread, that was marked solved.
Anyway, ISDN PRI works on all cisco router, not just 2900.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: