Solved: Singapore +ISDN10 to CME on a 2811 ?

andyhibbert · ‎06-25-2009

It's a long shot but has anyone any experience on connecting an ISDN10 from SingTel in Singapore to a CME on a 2811 router? I guessing a VWIC2-1MFT-T1/E1 would be the right interface card?

What framing and line code are required also is this a PRI or R2 type trunk?

A sample working config would be greatly appreciated.

Thanks

paolo bevilacqua · ‎06-25-2009

That is the right card. As the name says, it's ISDN PRI. You configure pri-group with ten channels and that's it. You also need a minimum of pvdm2-16.

View solution in original post

paolo bevilacqua · ‎06-25-2009

That is the right card. As the name says, it's ISDN PRI. You configure pri-group with ten channels and that's it. You also need a minimum of pvdm2-16.

andyhibbert · ‎06-26-2009

Thanks.

Anil Verma · ‎07-16-2013

Hi

Were you able to get this to work?

I am looking at some Cisco docs that say it's supported in 2900 only

Thanks

paolo bevilacqua · ‎07-16-2013

You are responding to a 4 years thread, that was marked solved.

Anyway, ISDN PRI works on all cisco router, not just 2900.