Etherchannel on ASA

Answered Question
Jun 25th, 2009

Hello

Is there a possibility to aggregate multiple ports into one logical channel on the Cisco ASA ?

Thank your advance

Regards

Lucas

I have this problem too.
0 votes
Correct Answer by thiland about 5 years 8 months ago

This is supported as of 8.4.1.

EtherChannel support (ASA 5510 and higher)

You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.

Note You  cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM  in slot 1 on the ASA 5550, as part of an EtherChannel.

We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.

http://www.cisco.com/en/US/docs/security/asa/asa84/release/notes/asarn84.html#wp432043

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (2 ratings)
Loading.
Correct Answer
thiland Thu, 05/12/2011 - 15:28

This is supported as of 8.4.1.

EtherChannel support (ASA 5510 and higher)

You can configure up to 48 802.3ad EtherChannels of eight active interfaces each.

Note You  cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM  in slot 1 on the ASA 5550, as part of an EtherChannel.

We introduced the following commands: channel-group, lacp port-priority, interface port-channel, lacp max-bundle, port-channel min-bundle, port-channel load-balance, lacp system-priority, clear lacp counters, show lacp, show port-channel.

http://www.cisco.com/en/US/docs/security/asa/asa84/release/notes/asarn84.html#wp432043

Actions

This Discussion