Cisco 2811 DTE - any way to see the clock rate from NTU/DSU/CSU?

Unanswered Question
Jun 25th, 2009

As per title, are there any commands that tell what the RX/TX clocks you are seeing from your service provider/network provider?

Show controllers tells you that there are TX and RX clocks present but nothing else with respect to clocks as far as I can tell.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
seangregg Thu, 06/25/2009 - 10:39


Tried that, only says that TX and RX clocks are present or something to that effect. No bandwidth or frequency value.


Paolo Bevilacqua Thu, 06/25/2009 - 10:43

Correct, not all hardware can read the clock values. You gotta trust what the SP says, or run some speed test.


This Discussion