Hi All,
I have a 1721 router with a WIC 4ESW 4 port switch card and an integrated T1 controller.
I have a T1 to the core of my network going into this Cisco 1721 router. I need have all the devices plugged into the 4 port switch on one network and the T1 controller on another network. These two networks converge at the 1721 router. When I plug the router in eigrp advertises the route of the serial interface that is directly connected. The problem that I am looking to solve is how can I get the network that I am using for the 4 port switch to advertise?
below is my config.
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname
!
boot-start-marker
boot system flash c1700-ipbasek9-mz.124-25a.bin
boot-end-marker
!
!
aaa new-model
!
!
aaa authentication login default local
aaa authentication login telnet local
!
aaa session-id common
clock timezone est -5
ip cef
!
!
no ip dhcp use vrf connected
ip dhcp excluded-address 10.143.0.0 10.143.2.0
ip dhcp excluded-address 10.143.2.4 10.143.255.255
!
ip dhcp pool 143
network 10.143.0.0 255.255.0.0
default-router 10.143.1.254
lease 0 8
!
!
no ip bootp server
no ip domain lookup
!
!
!
!
!
!
interface FastEthernet0
no ip address
speed auto
!
interface FastEthernet1
!
interface FastEthernet2
!
interface FastEthernet3
!
interface FastEthernet4
!
interface Serial0
ip address 192.168.143.2 255.255.255.0
!
interface Vlan1
ip address 10.143.1.1 255.255.0.0
!
router eigrp 1
network 10.0.0.0
network 192.168.143.0
no auto-summary
no eigrp log-neighbor-changes
!
ip default-gateway 10.143.1.254
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 192.168.143.1
!
no ip http server
no ip http secure-server
!
control-plane
!
!
line con 0
login authentication telnet
line aux 0
line vty 0 4
login authentication telnet
!
ntp server 10.220.42.200 prefer
end
