PBR on 1811

Unanswered Question
Jun 27th, 2009

I have just acquired and used 1811. I want to put the http traffic on FE1 and the other traffic on FE0.

One of the LAN ports will go to the ASA that will do the rest of the firewall and routing.

I need to setup policy based routing, but dont seem to find anything about this in the docs.

Can someone give me push in the right direction.

thank you!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
markworsnop Sat, 06/27/2009 - 09:31

I guess in this doc its there somewhere, but after reading it I didnt see where I can router http on one WAN and everything on the other. I did see lots of balancing and route on IP but nothing on the type of traffic. What is the set of commands that would do this?

Actions

This Discussion