Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
340
Views
0
Helpful
3
Replies

PBR on 1811

markworsnop
Level 1
Level 1

‎06-27-2009 04:43 AM - edited ‎03-04-2019 05:15 AM

I have just acquired and used 1811. I want to put the http traffic on FE1 and the other traffic on FE0.

One of the LAN ports will go to the ASA that will do the rest of the firewall and routing.

I need to setup policy based routing, but dont seem to find anything about this in the docs.

Can someone give me push in the right direction.

thank you!

Labels:
0 Helpful
3 Replies 3

markworsnop
Level 1
Level 1

‎06-27-2009 09:31 AM

I guess in this doc its there somewhere, but after reading it I didnt see where I can router http on one WAN and everything on the other. I did see lots of balancing and route on IP but nothing on the type of traffic. What is the set of commands that would do this?

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to markworsnop

‎06-27-2009 01:37 PM

Match port or equivalent ACL.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card