06-27-2009 10:53 AM - last edited on 03-25-2019 03:25 PM by ciscomoderator
-----QUESTIONS-----
⢠Configure the link between ROUTER _4 and ROUTER_5 using PPP encapsulation.
⢠Configure ROUTER_4 to request ROUTER_5 to authenticate via PPP.
⢠ROUTER_5 should respond with the username ROUTER5 and the clear-text
password CISCO.
⢠Configure ROUTE_5 to request ROUTER_4 to authenticate via PPP.
⢠ROUTER_4 should reply with the username ROUTER4 and an MD5 hash value that
represents the password CISCO.
--------ANSWER----------
R4:
username ROUTER5 password 0 CISCO
!
interface Serial0/1
encapsulation ppp
ppp authentication pap
R5:
username ROUTER4 password 0 CISCO
!
interface Serial0/1
encapsulation ppp
clockrate 64000
ppp authentication chap
ppp pap sent-username ROUTER5 password 0 CISCO
--------
My question is this, since ROUTER5 is requestin R4 to authenticate through CHAP.
Don't I need to configure below on ROUTER 4 serial interface...
ppp chap hostname ROUTER4
ppp chap password CISCO
Solved! Go to Solution.
06-28-2009 10:27 AM
Kennie,
You need because the router will use hostname by default.
HTH,
Toshi
06-27-2009 05:46 PM
You do unless the hostname of the router itself is ROUTER4.
___
Edison.
06-28-2009 10:27 AM
Kennie,
You need because the router will use hostname by default.
HTH,
Toshi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: