cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
246
Views
5
Helpful
1
Replies

Firewall Active/Standby connection to Dual Core Inside network

Hi,

I have dual core L3 Switches (4503-E) in LAN. I want to connected this Core network as Inside to Active/Failover setup. Then to connect Firewall cluster to internet through a 2821 router

Can anyboby elaborate what is the best way to achieve this. I want to do NAT in firewalls. I have only 6 public IP addresses for LAN segent.I want to eliminate single point of failure for connection from dual core to firewall cluster

regards,

Waruna

1 Reply 1

Kureli Sankar
Cisco Employee
Cisco Employee

You need inter chassis active/standby failover.

You can do HSRP on the inside and outside vlans on the MSFC.

Pls. read here:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm32/configuration/guide/fail_f.html#wp1142744

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: