Network Assistans IOS Command Not Found

Unanswered Question
Jun 29th, 2009
User Badges:

I have Cisco Network Assistant, I am attempting to connect to Cisco 4402 WLAN Controller. However, on descovery I get "IOS Command Not Found". Can anyone help me connect ? Many thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
carenas123 Fri, 07/03/2009 - 05:03
User Badges:
  • Silver, 250 points or more

Network Assistant supports only autonomous access points. Access points that are managed by a wireless LAN controller are not supported.

If you run Cisco IOS 12.2(25)SEE or later, Cisco IOS 12.2(25)SEG or later, or Cisco IOS 12.1(22)EA7 or later, you must run Network Assistant 4.0 or later.

neilmac Fri, 07/03/2009 - 05:17
User Badges:

Thanks for the answer -

It's not the Access Points I want to connect to, it's the WLAN controller.


Lucien Avramov Fri, 07/03/2009 - 17:09
User Badges:
  • Red, 2250 points or more

The WLAN controllers are not supported in CNA per the release notes. Keep in mind CNA was designed for switch management.

For WLC management, you can use other products such as WCS.


This Discussion