I am trying to set-up "click to dial" in Outlook using the following:
- SPA942 IP Phone
- 3rd party TAPI driver called SIPTAPI
I have configured the Tapi driver as follows:
SIP Domain: 192.168.1.202:6060
SIP Outbound Proxy: left blank (but have also tried IP address of phone)
User: the IP phones extension (also tried ITSP ID)
Password: left blank as no paswword (also tried ITSP password)
I have also tried about 100 other combinations but I cannot get Outlook to successfully place the call - nothing happens.
Does anyone have configuration suggestions or another TAPI driver / solution that I could use.