06-30-2009 11:06 AM
While trying to do a compliance and deploy job- for an access-list, it it only deploying part of the job. I have to run it twice to get the entire access-list applied. Happens on both 3.1 and 2.6.
06-30-2009 11:27 AM
What protocol are you using for deployment? Exactly what commands are you deploying?
06-30-2009 11:30 AM
I am checking for compliance and deploying -- using a template we created
+ access-list 8 XXX.XXX.XXX.XXX
+ access-list 8 XXX.XXX.XXX.XXX
etc
06-30-2009 11:32 AM
I'm interested in the etc. If you are using SSH to deploy these commands, and there is more than 1024 bytes being deployed, then you are most likely running into a known bug.
06-30-2009 11:33 AM
Okay-
So if the access list has 20 lines-- and we use SSH-- thats the problem?
I did notice it went on two devices fine--and those devices use telnet. I should have realized that and included that in the post.
Is there a fix?
06-30-2009 11:43 AM
The bug is fixed in LMS 3.2 which is currently available. There are patches for 3.1 available by contacting the TAC. This particular bug is CSCsx24218.
06-30-2009 11:46 AM
Thanks-- I will contact the TAC right away. I appreciate this--
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: