Solved: ip policy route-map command is not working

petero007 · ‎06-30-2009

Hi,

I tried to apply the ip policy route-map command to an interface vlan X, but is not working.

The IOS version is:c3560-advipservicesk9-mz.122-25.SEE4.bin

I searched on Cisco and it looks like PBR is supported in this IOS.

The show ip interface vlan X command shows policy routing is disabled and there is no access-list set.

So, PBR is not working. There are no packet matches against route-maps.

Thanks all.

Edison Ortiz · ‎06-30-2009

Make sure you have the 'dual-ipv4-and-ipv6 routing' template applied on the switch. The default template is desktop which does not support PBR.

HTH,

__

Edison.

Edison Ortiz · ‎06-30-2009

Make sure you have the 'dual-ipv4-and-ipv6 routing' template applied on the switch. The default template is desktop which does not support PBR.

HTH,

__

Edison.

petero007 · ‎06-30-2009

Hi Edison,

I applied the "desktop routing" template because i no need IPV6 support, and then, PBR works fine.

Thanks for all.

Skyneon · ‎12-17-2020

Thx you, only switch to dual-ipv4-and-ipv6 routing helps to fix the issue on C3750-X