Can Not Transfer to analogue cordless on UC520 -> Ports FXS 0/0/2

jpotamitis1 · ‎07-01-2009

Hi All,

System UC520

I can call the the analogue extension the cordless phone is on but i can NOT Transfer to it. Is there anything i should enable to allow transfer to analogue port?

below is the running config for that port.

voice-port 0/0/2
cptone AU
timeouts ringing infinity
station-id name FXS Port
station-id number 194
caller-id enable
!

Thanks in advance

bcransto · ‎07-27-2009

jpotamitis1,

In UC500/CME you should be able to transfer amongst SCCP endpoints without issue and by default. The issue comes in with transfering to POTS or Analog ports, and this is by design for security purposes. To enable the transfer you need to add some transfer patterns to the telephony service like this:

telephony-service

transfer-pattern .T

Check out the SRND guide for CUCME on this topic at: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/srnd/design/guide/clproc.html#wp1068396

And also the reference guide for the specifics on the command options as you might not want to allow a call to be transfered to "anywhere". The guide is here: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_t1ht.html#wp1018955

Have a great day!

-Ben

Laura Douglas · ‎08-18-2009

Hello,

I moved this to the UC500 section of the Small Business Support Community so others could benefit from the discussion.

Laura Douglas

Cisco Collaboration Community Manager

Steven Smith · ‎08-19-2009

You should be able to make this transfer work. Can you post your config?