phones connected to my ATA don't have dial tone

Unanswered Question
Jul 2nd, 2009
User Badges:

Guys! pls help me out...


THIS IS MY SET UP:


PSTN ---- 2801 ROUTER ---- ATA 186 ---- PORT 1 analog phone PORT 2 fax machine


I have a cisco ATA 186 connect to my 2801 CME for two months it runs smoothly with no problem at all. My problem started a week ago when i observed that the phone connected to phone 1 port on my ATA don't have dial tone. What i did was, i power rebooted the ATA and the dial tone was back again. The next day same phone don't have dial tone again so what i did i changed the analog phone connected to phone 1 port with another analog phone with a different brand from the previous phone that was connected. Same thing happens every now and then, sometimes the phone connected to the phone 2 port don't have dial tone. I just power reboot it so that it dial tone again.


Suggestions are highly appreciated. Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
vmtimaan2k4 Thu, 07/02/2009 - 16:53
User Badges:

What do you mean spare device? another ATA? I don't have an extra ATA..

vmtimaan2k4 Thu, 07/02/2009 - 19:49
User Badges:

Why is that most of the time the ordinary analog phone connected to port 1 will not have dial tone? If there's a problem with the fax machine it should be the fax machine which is connected to port 2 of the ATA will be the one that will not have dial tone.

Actions

This Discussion