Auto RF Problems

Unanswered Question
Jul 2nd, 2009
User Badges:

Hi Guys,


I have problem for Auto RF.I have environment with 40 AP 1131AG,WLC 4402-50AP using 4.2.130.


Problem:AP no Auto Power the controller set Level power to Maximum. AP to AP interval 10 m of no obstruction.


I config Auto RF by Default


Can you help me to explain the problem



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Fri, 07/03/2009 - 10:16
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Depending where the ap's are placed and how many ap's can be heard at a given ap location, RRM adjusts the power of the access points only when an access point sees the 3rd neighbor at -65 dbm or greater. It is possible that the 3rd ap signal is not strong enough to trigger RRM TX power.


http://www.cisco.com/en/US/customer/tech/tk722/tk809/technologies_tech_note09186a008072c759.shtml#tpca


wackerk24 Sat, 07/04/2009 - 09:04
User Badges:

Fella5 is correct, I just want to point out however in your environment it would be -70dbm or greater because of the code you're running.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode