FWSM and IPv6 Network configuration

Unanswered Question
Jul 3rd, 2009

I would like to seek advices regarding to Cisco Firewall Module [WS-SVC-FWM-1] and IPv6 network.

At this moment, our server farm is capable to support IPv4/IPv6 network, and our servers are starting to use both to serve our end-users.

My questions are:

1. I enabled IPv6 on Cisco Firewall Module [WS-SVC-FWM-1], especially configured 'ipv6 address autoconfig' in interface level

2. in CLI mode, I can control IPv4 rule and IPv6 rule, But in ASDM I can't control IPv4 rule

(can't edit rule and apply rule)

is it bug ?

3. in FWSM redundancy, IPv4 no problem (can configuring standby ip) but how can I config standby ip in IPv6 address

======================================

show version

FWSM Firewall Version 4.0(6)

Device Manager Version 6.1(4)F

Compiled on Fri 17-Apr-09 15:33 by fwsmbld

FWSM up 20 days 15 hours

Hardware: WS-SVC-FWM-1, 1024 MB RAM, CPU Pentium III 1000 MHz

Flash TOSHIBA THNCF128MBA @ 0xc321, 20MB

....

interface Vlan30

nameif outside

security-level 0

ip address 192.168.3.251 255.255.255.0 standby 192.168.3.252

ipv6 address 2001:1:1:1::1/128

ipv6 address autoconfig

ipv6 enable

!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion