I need to gain access to admin context which is located on FWSM module. I don't know it IP-addresses, because other man performed configuration before me. The command "session slot" didn't help me:
session slot 3 processor 1
The default escape character is Ctrl-^, then x.
You can also type 'exit' at the remote prompt to end the session
Trying 127.0.0.31 ...
% Connection refused by remote host
There are two other contexts on it (not admin). I can log to this contexts. But I can't âchangetoâ admin context because of privileges absence.
My question is the next. Is it possible to log to admin context in my situation without resetting the module? How?
0x105A978 10.X.1.Y:23 10.X.28.Y:22498 ESTAB
0x105B53C 10.X.0.Z:23 10.X.48.Z:1121 ESTAB
You would see 127.0.0.31 as the IP address for the module in slot 3. But, I do not see that in the output.
If you reload the blade I am sure you will be able to session in after which you can upgrade.
If you are not sure of the password to session in the only way is to do password recovery.
You can read here: