CEoIP PBX end to end loopback

Unanswered Question
Jul 6th, 2009
User Badges:

I have 2x3845 with CEM E1 connecting to NEC PBX. the CEM circuit is up but i can't perform loopback test to the PBX to other PBX side.

I tried to use loopback network forn the E1 router controller, and i am getting nothing at the PBX site.

loopback local line from each Router to the PBX on the same site is OK.


Advice


Thanks & Regards

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Mon, 07/06/2009 - 07:20
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Use an RJ45 loopback plug.

mugahid-mustafa Wed, 07/08/2009 - 23:53
User Badges:

Hello,

I tried, but i can't get singnal/flash on the BPX on the other end.


I will move 1 router to the other site and i will connect both back-to-back, and then i will perform loopback.

hope it will work


mugahid-mustafa Thu, 07/09/2009 - 04:31
User Badges:

Hi All,

How to check weather there is a traffic passing throuhg CEoIP circuit.

Any debug, or capture application?


Thnx


Actions

This Discussion