Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
442
Views
0
Helpful
3
Replies

CEoIP PBX end to end loopback

mugahid-mustafa
Level 1
Level 1

‎07-06-2009 07:11 AM - edited ‎03-18-2019 10:27 AM

I have 2x3845 with CEM E1 connecting to NEC PBX. the CEM circuit is up but i can't perform loopback test to the PBX to other PBX side.

I tried to use loopback network forn the E1 router controller, and i am getting nothing at the PBX site.

loopback local line from each Router to the PBX on the same site is OK.

Advice

Thanks & Regards

Labels:
0 Helpful
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

‎07-06-2009 07:20 AM

Use an RJ45 loopback plug.

0 Helpful

mugahid-mustafa
Level 1
Level 1
In response to paolo bevilacqua

‎07-08-2009 11:53 PM

Hello,

I tried, but i can't get singnal/flash on the BPX on the other end.

I will move 1 router to the other site and i will connect both back-to-back, and then i will perform loopback.

hope it will work

0 Helpful

mugahid-mustafa
Level 1
Level 1
In response to mugahid-mustafa

‎07-09-2009 04:31 AM

Hi All,

How to check weather there is a traffic passing throuhg CEoIP circuit.

Any debug, or capture application?

Thnx

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents