07-06-2009 08:09 AM
Hi,
I am running IP SLA for udp-jitter operation (jitter/latency/RTT measure) on cisco 2691 router. I want RMON to be configured so that traps can be sent to NMS when crossing threshold. When i am creating RMON alarm for any "rttMonJitter*" operation , it gives me an error that it is a unknown object.
can someone suggest what shud be done in this scenario?
rgds
07-06-2009 08:53 AM
Why use RMON? Why not use an IP SLA trigger to send a trap instead? You can configure a reaction type to occur when the average jitter crosses the threshold defined in your collector. The action can then be to send an rttMonNotification trap from the CISCO-RTTMON-MIB.
07-06-2009 09:11 PM
thanks for the response...
yes, i can certainly use reaction-trigger of IPSLA, but the problem is that i am having more than 500 IP SLA configured, so if i use reaction-trigger then it wud be for per SLA config..
if i use RMON, then it wud be general for all IP SLAs.
rgds
07-06-2009 09:44 PM
No, you'll still need to specify an index for the RMON alarm; so you'll need an RMON alarm for each collector. It would be easier to create the IP SLA reactions.
07-06-2009 10:29 PM
no, i don't require to give each index of IP SLA, that is common for all indexes..
rgds
07-06-2009 10:40 PM
There is no such object in the CISCO-RTTMON-MIB that will give you a combined or average jitter across all configured collectors. You will need to watch the jitter values for each collector individually.
07-06-2009 10:48 PM
hi,
just see this config:
rmon event 100 log trap public owner NNM
rmon alarm 10 rttMonLatestJitterOperRTTMax 40 absolute rising-threshold 5 100 falling-threshold 1 owner NNM
this will send the trap of each index of IP SLA to NMS
rgds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: