WCS: Profile Name-VLAN Mappings

Unanswered Question
Jul 7th, 2009
User Badges:

Hi everyone.

I'm running WCS 6.0.132 with WLC 6.0.182 and I'm trying to build a Lightweight AP template to assign NAME-VLAN mapping on different AP running H-REAP.

When I create the new template I setup AP in H-REAP mode and then enable H-REAP/REAP configuration with VLAN support but the box in which I'm supposed to find the mapping list is always blank (even, of course, after use the "Show All Profile Mapping" option).

The controller on which I'm running is already running H-REAP AP with mapping and I've already refreshed the configuration from controller into WCS.

Any idea?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Lucien Avramov Wed, 07/08/2009 - 22:03
User Badges:
  • Red, 2250 points or more

Modification, you are facing a newer defect than the one i mentionned earlier. Tac should be able to communicate that to you.

The issue should be fixed in the next release of WCS 6.0

There is a workaround until then :

You can use wcs for configuring H-reap group via the configure AP page for a particular AP.

Another workaround would be to use the WLC CLI or the WLC GUI.

messaggerielibri Wed, 07/08/2009 - 22:17
User Badges:

Lucien, thanks for your infos.

In the meanwhile I was able to open a TAC case (611897361 if you like to "chat" with your colleague on that) and the support engineer already mentioned the bug.

Anyway either the workarounds are one by one manually solution, right?

Any possible comment on the upcoming version release date?


Lucien Avramov Wed, 07/08/2009 - 22:37
User Badges:
  • Red, 2250 points or more

Glad you did. I believe the defect is different than the one i mentioned earlier, the TAC engineer will be able to provide you with the defect number once published.

You are correct, it's a one by one solution for such workaround.

Last I heard for the upcoming release should be coming early fall, I would suggest you to double check on your TAC case, the developper team may have a different ETA.

reginald-pugh Sat, 10/17/2009 - 09:41
User Badges:

Was this fixed ? We are having similiar issue using code on the controllers and on WCS. No profile appear in window on the template creation.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode