Devices in conflicting & suspended state

Unanswered Question
Jul 8th, 2009
User Badges:

Hi Team


Devices are stuck in conflicting and suspended state.I am able to telnet these devices from LMS as well as it is also showing in RME.


We are getting this error while clicking on any device.


Regards

Vaibhav



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Wed, 07/08/2009 - 10:12
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Are the devices suspended or conflicting? Go to RME > Devices > Device Management > Suspended Devices and Conflicting Devices, and see if the devices are listed there. For Suspended Devices, resume them. For Conflicting Devices, you will need to adjust the DCR device type to match the actual device type being managed. It is recommended to leave the DCR device type as Unknown so that the applications can figure out what type of device it is.

Actions

This Discussion