WLC HREAP

Unanswered Question
Jul 8th, 2009
User Badges:

Hi,

I have configured HREAP but not applied to any AP, My question is when i view the AP config i see the AP group name as none and for other ap as "group-default" can anyone tell me why am i seeing this??


Thanks

Sum

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 07/08/2009 - 15:32
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Apply HREAP to your AP, create a new AP Group and put the AP's there.

sumaiyausa Wed, 07/08/2009 - 23:41
User Badges:

Hello leo,

Thanks for the update. I know when i apply the HREAP to AP it works but my question was why is the AP mode getting "default-group mode" and "none" mode for some AP without applying the HREAP config on them.


Whats the difference between them(i.e default group and none)?


Regards,

SUm


Roman Rodichev Sat, 07/11/2009 - 14:09
User Badges:
  • Gold, 750 points or more

Are you planning on doing HREAP local switching or central switching? If you are going to be doing local switching, I don't believe that AP group have any effect on HREAPs. HREAP will use VLAN mappings under HREAP's configuration. I believe that AP groups only apply when you do central switching.


Also don't confuse AP groups with HREAP groups. Two different things.


Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode