cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
617
Views
0
Helpful
5
Replies

config backup of devices via LMS

jain.nitin
Level 3
Level 3

is it possible to have backup of some devices daily & for some devices weekly ?

if yes then how can I achieve this.

Thanks

1 Accepted Solution

Accepted Solutions

Disable the system config collection job under RME > Admin > Config Mgmt > Collection Settings. Then, go to RME > Config Mgmt > Archive Mgmt > Sync Archive, and schedule a new job to run. Above the device selector, you will see a radio button that says Group Selector. Choose this button, then select the group or groups for which configs should be collected. You should also check the Fetch Startup box.

This job will then collect configs from the dynamic set of devices which are members of the selected groups. You can then schedule another job for the different time table.

If you use the default Device Selector instead of the Group Selector, the device list used will be static. As you add new devices to RME, the job will not change to incorporate those new devices.

View solution in original post

5 Replies 5

Joe Clarke
Cisco Employee
Cisco Employee

What version of RME are you using?

Its the latest version I can not recall, Need to know how it is possible...

Post a screenshot of Common Services > Software Center > Software Update.

here is the snap shot as requested

Disable the system config collection job under RME > Admin > Config Mgmt > Collection Settings. Then, go to RME > Config Mgmt > Archive Mgmt > Sync Archive, and schedule a new job to run. Above the device selector, you will see a radio button that says Group Selector. Choose this button, then select the group or groups for which configs should be collected. You should also check the Fetch Startup box.

This job will then collect configs from the dynamic set of devices which are members of the selected groups. You can then schedule another job for the different time table.

If you use the default Device Selector instead of the Group Selector, the device list used will be static. As you add new devices to RME, the job will not change to incorporate those new devices.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco