Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
354
Views
0
Helpful
1
Replies

ccme T1 Connection

sunnyverghese
Level 1
Level 1

‎07-08-2009 11:48 AM - edited ‎03-17-2019 09:46 PM

i have one t1 connection and Toll by pass is already configured in the ccme .

i would like to add one more t1 and segregate the toll by pass calls only through new t1 .

is it possible and what hardware is needed for this and do we require more dsp resources for this ?

Labels:
0 Helpful
1 Reply 1

Nicholas Matthews
Level 9
Level 9

‎07-08-2009 11:53 AM

Yes, this is easily done. On your toll bypass dial peers just make sure that the destination port is the one you're wanting to use.

If you are using another PRI, you will want additional DSPs, correct. The DSP calculator is helpful for calculating this: http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

hth,

nick

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents