07-08-2009 07:35 PM - edited 03-10-2019 04:35 PM
Hi Guys,
I'm planning to use AAA authorization using local database. I have read already about it, I have configured the AAA new-model command and I have setup user's already. But I'm stuck at the part where I will already give certain user access to certain commands using local database. Hope you can help on this.
FYI: I know using ACS/TACACS+/RADIUS is much more easy and powerful but my company will most likely only use local database.
07-09-2009 07:54 AM
For allowing limited read only access , use this example,
We need these commands on the switch
Switch(config)#do sh run | in priv
username admin privilege 15 password 0 cisco123!
username test privilege 0 password 0 cisco
privilege exec level 0 show ip interface brief
privilege exec level 0 show ip interface
privilege exec level 0 show interface
privilege exec level 0 show switch
No need for user to login to enable mode. All priv 0 commands are now there in the user mode. See below
User Access Verification
Username: test
Password:
Switch>show ?
diagnostic Show command for diagnostic
flash1: display information about flash1: file system
flash: display information about flash: file system
interfaces Interface status and configuration
ip IP information
switch show information about the stack ring
Switch>show switch
Switch/Stack Mac Address : 0015.f9c1.ca80
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master 0015.f9c1.ca80 1 0 Ready
Switch>show run
^
% Invalid input detected at '^' marker.
Switch>show aaa server
^
% Invalid input detected at '^' marker.
Switch>show inter
Switch>show interfaces
Vlan1 is up, line protocol is up
Hardware is EtherSVI, address is 0015.f9c1.cac0 (bia 0015.f9c1.cac0)
Internet address is 192.168.26.3/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Switch>
Please check this link,
http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml
Regards,
~JG
Do rate helpful posts
07-09-2009 06:11 PM
Hi JG,
Thanks for your reply and it is very helpful. I just like to confirm that what you showed is using AAA authorization on local database, right?
Regards,
John
07-09-2009 09:24 PM
Hi JG,
One more thing can you enlighten me about the command "privilege interface and privilege configure"? Or do you have a link that discusses this commands?
Thanks.
John
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide