Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
261
Views
0
Helpful
2
Replies

Configuring new E1 MFT

simonmossman
Level 1
Level 1

‎07-09-2009 12:38 AM - edited ‎03-15-2019 06:53 PM

Hi all

Can you please confirm the correct configuration for a new E1 card install. Currently I have 1 30 channel E1 installed in the 3825 VG. I am assuming all I will have to do is add the controller and timeslots and I should be good to go. Then just add the translation patterns in the CUCM

Look forward to a reply

thanks

Simon

Labels:
0 Helpful
2 Replies 2

KonradStepniewski
Level 3
Level 3

‎07-09-2009 02:31 AM

It should be enough if you use MGCP as protocol. Still keep in mind you need DSP to use this E1 card.

Check your show diag DSP info with DSP calculator: http://www.cisco.com/cgi-bin/Support/DSP/cisco_prodsel.pl

rate if this help

0 Helpful

simonmossman
Level 1
Level 1
In response to KonradStepniewski

‎07-09-2009 06:29 AM

Thanks Konrad

The DSP tool is cool

0 Helpful
Customers Also Viewed These Support Documents