LMS : Config Collection â€œPartional Successfulâ€ message

dkuhlen-goebel · ‎07-09-2009

Dear All

Szenario:We have 2 CW Server one CWLMS2.6 and one CWLMS3.1 based on Solaris.

For CM3.1 I have the following problem:

If I make a Config Collection for a specific device or the entiry network I get a lot of â€œPartional Successfulâ€ Status messages. A lot of this messages are â€œVLAN RUNNING Config fetch failed for â€¦.. Cause: VLAN Config is not supported using TFTPâ€

The startup and runnig Config is collected without problems.

The Transport Setting on both systems are Telnet, ssh, tftp.

CW2.6 has no failure during the config fetch.

What is wrong?

Thanks

yjdabear · ‎07-09-2009

The following post enumerates all the prerequisites to get VLAN archiving going. Doublecheck that your LMS 3.1 instance meets them:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cd34b8d/0#selected_message

dkuhlen-goebel · ‎08-05-2009

We tested all required ports, but the results are fine - all ports are open. (Of course the behavior doesn't change.) Do you have an other suggestion?

Thanks for your help.

LMS : Config Collection âPartional Successfulâ message

LMS : Config Collection âPartional Successfulâ message