07-09-2009 05:03 AM
In my DCR there are several devices (most of them 3560) which are marked as unknown device type, but CM identifies them correctly. SNMP Walk from Device Center works fine too. CS is 3.2.0 (MDF 1.23) and CM 5.1.3.
Any ideas what could be the reason why the device type is not updated?
07-09-2009 06:37 AM
Post the sysObjectID of the devices and the NMSROOT/lib/classpath/com/cisco/nm/cwcs/mdf/mdfdata.xml file.
07-09-2009 07:01 AM
07-09-2009 07:05 AM
Are these devices also managed by RME? If so, has their inventory been collected successfully?
07-09-2009 08:14 AM
Seems to be a problem caused by an bulk import of these devices. Checking the last Device Discovery Summary, I could not find one of them.
I'm just wondering that CM works fine.
07-09-2009 10:12 AM
Data Collection works independently from the MDF. Hence Campus can properly show the device type, but there may be a problem with DCR, or with some other application. That is why I asked if RME was managing these switches.
07-09-2009 10:51 PM
Hi jclarke,
I think I found it. CW conntects these devices through NAT and I set an discovery filter, which excludes the real ip addresses.
It seems, that CSDiscovery apply the filter to the real and not the NAT adresses. Am I right with this assumption?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide