need a corlist guru

Unanswered Question
Jul 9th, 2009
User Badges:

Customer has a UC520 trying to separate only 911 calls between two sites. Remote site has a gateway with fxo port. This is the set up I used and when the customer at hartford end calls 911 it goes out the wtby end instead of out the pri. Happens every single time. If you remove the voip peer the call goes out

the pri. I don't get it.


dial-peer cor list call-911-htfd

member emergency

!

dial-peer cor list call-911-wtby

member emergency


dial-peer voice 155 pots

corlist outgoing call-911-htfd

description ** T1 pots dial-peer **-Emergency dial-peer

translation-profile outgoing CALLER_ID_TRANSLATION_PROFILE

destination-pattern 911

port 0/3/0:23

forward-digits 3

no sip-register


dial-peer voice 4000 voip

corlist outgoing call-911-wtby

description ** Waterbury Emergency Dial Peer **

destination-pattern 911

session target ipv4:10.1.2.2

dtmf-relay h245-alphanumeric

codec g711ulaw

no vad


ephone-dn 19 dual-line

number 5824 secondary 5824 no-reg primary

label Esther Burgos 5824

description Esther Burgos

name Esther Burgos

call-forward busy 5809

call-forward noan 5809 timeout 10

corlist incoming call-911-


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Buffin Thu, 07/09/2009 - 07:35
User Badges:
  • Purple, 4500 points or more

I believe you would need something like (parts omitted):


dial-peer cor custom

name 911-htfd

name 911-wtby


dial-peer cor list call-911-htfd

member 911-htfd


dial-peer cor list call-911-wtby

member 911-wtby


dial-peer voice 155 pots

corlist outgoing call-911-htfd


dial-peer voice 4000 voip

corlist outgoing call-911-wtby


ephone-dn 19 dual-line

corlist incoming call-911-htfd


ephone-dn 20 dual-line

corlist incoming call-911-wtby


In this case, ephone-dn 19 would use dial peer 155 and ephone-dn 20 would use dial peer 4000.


Hope this helps.


Brandon

Actions

This Discussion