07-10-2009 05:03 AM - edited 03-17-2019 09:46 PM
Hello,
I have an mcu 3515. I would like configure the EMP port setting. What is the command to do this ? Is there many commande to troubleshoot in cli mode ?
Thanks,
07-12-2009 10:50 PM
Hi!
In the VxWorks type the command "modifyTargetDevice". After that you will see the menu configuration.
Regards!
07-14-2009 07:03 AM
hi,
Thanks for your answer. Is there another command in this mode to configure or troubleshooting the mcu ?
07-15-2009 07:30 AM
You can restart o rest the EMP module, and enter into the configuration menu ... press any key to star the configuration ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: