guillermohurtado Fri, 07/10/2009 - 06:02
User Badges:

Hello,


Is there a command to kill/end a specific call on a Cisco GW AS5300/AS54000 ??


Regards.

Nicholas Matthews Mon, 07/13/2009 - 09:32
User Badges:
  • Red, 2250 points or more

If you use 'show call active voice brief' you can get the 4 digit HEX ID for a call based on calling/called number and remote IP address and channel.


Then you can use the command:

clear call voice causecode id , you can also try using the called/calling options instead of ID.



hth,

nick


guillermohurtado Tue, 07/14/2009 - 06:27
User Badges:

Hello,


I can't run that command. I just have:


GW#clear call ?

fallback VoIP Fallback

threshold Clear stats about resource measurement

treatment Clear commands for call admission


Is there another way to perform this?


Best regards.

Nicholas Matthews Tue, 07/14/2009 - 11:19
User Badges:
  • Red, 2250 points or more

It sounds like you need to upgrade IOS to use this command.


There isn't another way, unless you shut down voiceports/controllers.



-nick

guillermohurtado Tue, 07/14/2009 - 11:39
User Badges:

Hello,


I'm running Version 12.3(26) over a AS5300, isn't it the latest?


Regards.

Actions

This Discussion