Problems adding new MGCP E1

Unanswered Question
Jul 11th, 2009

Hi all

I have added a new E1 card in our mgcp GW and can see it in the sh diag and sh inventory. However when I try to add the controller e1 0/1/0 or 0/0/1 etc (we already have a card in 0/0/0) it does not take. I have moved the card into all the other slots and the same. We are running c2800nm-spservicesk9-mz.124-18.bin. I have set up the E1 on the CUCM 5.0 exactly the same as the other? I have used the 0/? on all options and it only gave me the 0 option ie 0/0/0 all the way

Any ideas?

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
rob.huffman Sat, 07/11/2009 - 10:36

Hi Simon,

This is usually an indication that you are short of DSP resources. Have a look at this excellent thread with some nice answers from Nick, Pedro and Sushil;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&topicID=.ee6c829&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cc2bc5f

Hope this helps!

Rob

Actions

This Discussion