cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1074
Views
0
Helpful
1
Replies

stacking-partner in cisco3825

zuhairy.mustafa
Level 1
Level 1

hi, i need help..

trying to stacks 2x NM-ESW-16 using

switchport stacking-partner cmd,

show interface gi1/0 switchport resulted as..

stack is active, interface is up but protocol is down. whats the problem? i can ping host in different module (means packet cant go thru stacks?)

1 Reply 1

brispin
Level 1
Level 1

It is normal to see "UP DOWN" on the interfaces used for stacking.

It is normal to see "UP DOWN" on the interfaces used for stacking. And as per the document if you remove stacking then the stacked ports will go to shutdown state. Basically when stacking is removed the stacked ports will move from "UP DOWN" to "DOWN DOWN" status.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco