07-12-2009 08:47 AM
Hi,
The attached is the output of the snmp walk on reacheable device,Which lines indicates that the device is reacheable through LMS????????
If suppose any of the devices not reacheable what would have been shown in SNMP Walk??????
Thanks
Solved! Go to Solution.
07-12-2009 09:32 PM
You will get the following error if the device is not reachable.
Failed to snmpwalk the device. Please check your community string and starting OID, and try again.
07-12-2009 03:19 PM
The fact that you got any response indicates that the device is reachable. If it had not been reachable, you would have gotten an error about the device being unreachable, and to check timeouts and credentials.
07-12-2009 08:51 PM
Hi,
From ur above mail i understand that if the device is unreacheable it will give an error otherwise not?? Correct me if am wrong.
Thanks,
07-12-2009 08:58 PM
It the device is not reachable as Joe said, you will have an error message.
In the attachment you posted, the device is clearly reachable as it responds to snmpwalk with the values for the OIDs it is queried.
07-12-2009 09:32 PM
You will get the following error if the device is not reachable.
Failed to snmpwalk the device. Please check your community string and starting OID, and try again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide